전염병 시대에 의료진은 감염과 싸우는 데 중요한 자원이되고 있습니다. 최고의 의료 서비스를 달성하기 위해 관련 기술과 절차는 감염위험을 줄이면서 의료진에게 가르쳐야 합니다. 혈액 배양은 효과적인 항 감염 치료 정권에 중요한 역할을합니다. COVID-19 환자가 손상된 폐 조직에서 세균성 초감염을 개발함에 따라 올바른 기술을 사용하여 혈액 배양 샘플을 얻고 항 감염 요법을 따르는 것이 중요합니다. 이 비디오는 혈액 배양을 얻는 데 필요한 재료와 올바른 방법을 보여줍니다.
Dear colleagues, in order to obtain appropriate blood cultures, ideally, two blood culture sets should be utilized. Each set consists of a bottle of aerobic and anaerobic bacteria and fungus. Additionally, two sterile needles and two syringes will be required.
Each of the syringes used here contains 24 milliliters of sterile blood obtained by vascular puncture. 8 milliliters of blood are injected into each bottle. One syringe is sufficient for a set.
The colored bottle top caps can be disposed of. The uncovered bottle top is sterile and should not be touched. The bottle tops may be disinfected with alcohol-containing disinfectant to ensure sterility.
No air should be injected into the blood culture bottles. Importantly, in order to reduce contamination of the anaerobic blood culture bottle, this should be filled as second. The needle must be attached to the syringe using aseptic technique.
The fungus culture bottle must be filled first. When the needle penetrates the membrane, ensure that the needle does not have direct contact with the disinfectant as there is a risk that the contained blood could be contaminated, in turn, killing any pathogens. The fungus blood culture bottle is filled with 8 milliliters of blood.
This bottle is now prepared. The anaerobic blood culture bottle must now be filled using the same procedure as before. The membrane is penetrated and 8 milliliters of blood injected.
The bottle is twisted once so that the contents are adequately mixed, and then placed to one side. The final 8 milliliters of blood are injected into the aerobic bacteria culture bottle. The first set is now complete.
The same procedure applies when preparing and utilizing the second set. Now it is important to label the sets of blood cultures appropriately. One complete set followed by the next.
Which bottle is involved? In this case, the aerobic bacteria bottle. Then the sample site, in this case, a Shaldon catheter.
One label per bottle is required, or a total of six labels. The transport bag is marked. Each set of cultures is placed in an individual transport bag.
The samples are packed and sent on to the microbiology laboratory. With COVID-19 patients, the transport bags should be marked explicitly so as to make all colleagues aware. Thank you very much.
