전염병 시대에 의료진은 감염과 싸우는 데 중요한 자원이되고 있습니다. 최고의 의료 서비스를 달성하기 위해 관련 기술과 절차는 감염위험을 줄이기 위해 의료진에게 가르쳐야 합니다. COVID-19 환자를 치료한 후 오염된 개인 보호 장비를 벗기면 감염성 에어로졸을 형성할 위험이 높으며 의료진의 감염으로 이어질 수 있습니다. 이 비디오에서는 자가 감염의 위험을 최소화하기 위해 개인 보호 장비를 벗는 방식이 표시됩니다.
Dearest colleagues, we have produced this film in order to highlight several important precautions which must be taken due to the current situation regarding COVID-19.
It is of particular importance to clarify the reusage of protective face masks. Remaining composed and maintaining concentration is also of high importance. An assistant should observe and assist with the doffing procedure of personal protection equipment until you are secure in your ability to carry this out independently. The recommendations in this film are based on international guidelines and recommendations. They apply solely to COVID-19.
The personal protective equipment will be removed before exiting the patient’s room. Firstly, open the lower cord of the protective gown. Then remove the gloves distally and dispose of them in the allocated black waste bin. Carry out a systematic and thorough hand disinfection. Use the elbow to attain three spurts of disinfectant and rub this into the hands until dry.
Open the neck cord. Do not rip the gown apart as this will lead to a dispersal of aerosol droplets or other contaminated materials. Pull the end of the sleeves over the hands and one after the other, pull your arms through the sleeves. Importantly only touch the protective gown from the inner or body contact surface. Roll the protective gown slowly together whilst only touching the inner side. Dispose of the protective gown in the allocated black waste bin. Disinfect your hands again using the same procedure as previously recommended.
If present, now remove the protective visor. Carry out a wipe disinfection and place the visor to the side to dry. The same procedure is applied to the protective glasses.
Remove the protective face mask by initially pulling the elastic straps away from each other, and also your head. Hold the protective mask from the lower edge so that the mask is not flicked with subsequent dissemination of aerosol. Hang the protective mask on the allocated hook. If you have used a cap, pull it upwards and off and dispose of it. Disinfect your hands once more, importantly including your forearms and elbows.
Store the protective glasses in the breast pocket of your work clothes. Remove the protective visor from the room and hang this on the allocated stand.
Before we end, we have several recommendations. For invasive procedures such as intubation or bronchoscopy, an FFP3 mask should be used instead of an FFP2. Please do not touch cabinets, door handles, respirators, PCs, or work surfaces with contaminated hands or gloves. Always remove gloves beforehand and disinfect your hands. When changing gloves, it is also essential to disinfect the hands, allowing time for the disinfectant to dry. Always place reusable materials such as needle holders or clamps in the white boxes in the room.
Thank you very much.
