Innovent e.V. 1 article published in JoVE Immunology and Infection Printing Thermoresponsive Reverse Molds for the Creation of Patterned Two-component Hydrogels for 3D Cell Culture Michael Müller1, Jana Becher2, Matthias Schnabelrauch2, Marcy Zenobi-Wong1 1Department of Health Science & Technology, Cartilage Engineering & Regeneration, 2Biomaterials Department, Innovent e.V. A bioprinter was used to create patterned hydrogels based on a sacrificial mold. The poloxamer mold was backfilled with a second hydrogel and then eluted, leaving voids which were filled with a third hydrogel. This method uses fast elution and good printability of poloxamer to generate complex architectures from biopolymers.