Bipolar Radiofrequency-Based Hemorrhage Arrest in Solid Organ Injury: A Technique to Arrest Bleeding in Porcine Model With Liver Injury Using Electrosurgery

Overview

This video demonstrates a technique of bipolar radiofrequency energy-based transcollation for hemorrhage arrest in solid organ injury in a porcine model. This method is helpful for the surgical management of traumatic injury by achieving hemostasis by arresting bleeding at the injury site.

Protocol

All procedures involving animal models have been reviewed by the local institutional animal care committee and the JoVE veterinary review board.

1. Model Preparation

1. House the 50 kg adult male pig in an animal care facility for 1 week prior to the surgery to acclimatize the animal to the housing conditions and the handlers. Fast the model for a minimum of 6 h prior to the initiation of anesthesia.
2. Anesthetize the model using an intramuscular injection of ketamine (33 mg/kg), atropine (0.04 mg/kg), and buprenorphine (0.05 mg/kg) as well as inhaled isoflurane (5%)⁹.
3. Move the model into the supine position and spray the vocal cords with lidocaine (1%) in order to prevent laryngospasm. Perform direct endotracheal intubation using a 6.5 Fr cuffed endotracheal tube. Confirm the correct position of the endotracheal tube using capnography.
4. Insert an 18G IV in the marginal ear vein and begin an infusion of Ringer's lactate at a rate of 200 mL/h. Apply a bland ointment to the model's eyes to prevent dryness while under general anesthesia.
5. Monitor the model's heart rate and oxygen saturation using a pulse oximeter applied to the model's tail. Ventilate the model between 14 - 16 breaths/min using a mechanical ventilator and a tidal volume of 5 - 10 mL/kg. Maintain an adequate anesthesia by targeting a minimal alveolar concentration (MAC) of isoflurane between 2 to 2.5.
6. Prior to the initiation of surgery, confirm the adequate depth of anesthesia by testing pain reflexes with a hind leg toe pinch. Reevaluate pain reflexes at regular intervals throughout the surgery.

2. Device Preparation

1. Prepare the ignited saline/bipolar radiofrequency (SBRF; Figure 1) device as per the manufacturer's specifications.
   1. Open the handpiece (6.0 bipolar sealing tip) and connect it to the generator.
   2. Set the saline flow rate setting to Low. Use 0.9% saline for a maximal energy conduction.
   3. Set the radiofrequency power setting to 160 W.

3. Surgery: Laparotomy

1. Perform a long open midline laparotomy incision using a #10 scalpel extending from the xiphisternum to the pubis and passing through all layers of the abdominal wall.
2. Establish an adequate exposure of the solid organs of interest (e.g., liver, spleen, kidney), mobilize other structures, and insert a retractor as necessary.
   NOTE: For simplicity, the liver will be referred to as the solid organ of interest for the remainder of this protocol. This protocol will also include creating injuries of similar grade within the kidney and spleen.

4. Surgery: Simulated Solid Organ Injury

NOTE: The injuries described below represent a worsening hierarchy of injuries. The injuries are created by an expert trauma surgeon and hemostasis will be obtained by another surgeon.

1. Using a #10 scalpel blade, apply an abrasive (back and forth) force to the liver capsule in order to induce capsular bleeding. The injury should be superficial (i.e., 1 - 2 mm) and 2 cm² in size. The size of the injury can then be increased in increments of 1 cm² at the operator's discretion.
2. Create solid organ lacerations of increasing severity using the direct application of a scalpel. The length of the laceration can extend from 5 cm to the entire length of the organ. The depth of the laceration should be 1 cm and then increased in increments of 1 cm at the operator's discretion.
3. Create penetrating injuries with a blunt device such as a Kelly clamp using a stabbing motion. These can be of a partial thickness (i.e., 50% of the organ) or of full thickness (i.e., passing completely through the organ).

5. Hemostasis

1. Depress the handpiece's button, initiating the simultaneous flow of saline and the delivery of bipolar radiofrequency energy. The saline will boil at the site of application.
2. Apply the device's tip directly onto the liver's raw surface, to superficial areas of bleeding, or within defects in the liver itself. Do not stab the organ with the end effector.
3. Apply concurrent suctioning from a standard surgical sucker as needed in order to deliver the heated saline and energy directly to the areas of ongoing hemorrhage. This also helps visualize the precise location of the ongoing hemorrhage.
4. Heat the tissues to approximately 100 °C (thermal coagulation without significant charring) using a gentle back and forth motion. An auditory 'pop' will occur after 3 - 5 s and signifies that the burn is complete. The user may then move the instrument in an organized manner to the next targeted site.
5. If necessary, apply precisely directed high-voltage electrocautery in conjunction with the application of the SBRF and suction devices in order to obtain hemostasis. This may be required for the largest and most vigorous hemorrhage.

6. Sealing Small to Medium Bile Ducts

1. Using the same method as described above, apply the instrument tip across the cut/injured edge of the liver parenchyma to seal small to medium bile ducts.

Representative Results

Figure 1: Saline/bipolar radiofrequency (SBRF) energy device. (A) This panel shows the SBRF device handpiece with the single-button design. (B) This panel shows the SBRF's 6.0 blunt bipolar sealing tip.

Materials

Name	Company	Catalog Number	Comments
Aquamantys pump generator	Medtronic	40-402-1
Aquamantys 6.0 bipolar sealer	Medtronic	23-112-1
Electrosurgical pencil with tip	Megadyne	39
Porcine animal
Porcine ventilator/induction and anesthetic medications
2 x 1 liter bags of 0.9% normal saline
2 x scalpels (#10)
Belfour abdominal retractor
Suction tubing
Suction tip
Suction device/wall connector
Suction canister
Debakey forceps
Metz scissors
Curved Mayo scissors
Closing suture (1-0 Nylon)
20 x Laparotomy sponges
2 x Kelley clamps
2 x snap clamps