Encyclopedia of Experiments: Immunology
A subscription to JoVE is required to view this content. Sign in or start your free trial.
Transcript
Heat and activate the serum samples in a water bath at 56 degrees Celsius for 45 to 60 minutes. Thaw a vial of virus, vortex, and resuspended in the sample diluent at the dilution that was selected. Prepare at least 5 milliliters of virus for each assay plate.
Keep the diluted virus on ice, until the plates are washed, and serum samples have been added to the plate. Prepare dilutions of the serum samples and any controls, by making serial two-fold dilutions in a round-bottom 96-well plate, beginning with a 1-in-10 10 dilution in sample diluent.
Use a multichannel pipette to transfer 50 microliters of each serum control or sample dilution from the dilution plate into duplicate wells of a washed fetuin-coated plate. The sample dilution should be added in columns 2 to 11. Add 50 microliters of diluted virus to all wells, except for the negative control in column 12.
Add 50 microliters of sample diluent to wells in column 1, and add 100 microliters of sample diluent to column 12. Cover the wells with a plate sealer, and then mix by gently tapping the sides of the plate or by placing it on a plate shaker at moderate speed for 10 seconds.
Place the plate in a humidified incubator at 37 degrees Celsius for 16 to 18 hours. When the overnight incubation is complete, wash the plate before adding PNA-HRPO, and complete the assay as before. Read the optical density at 490 nanometers, and confirm that the assay results are valid. Determine the 50% endpoint titer, as described in the text protocol and the results section.
