JoVE Science Education
Coronavirus / COVID-19 Procedures
This content is Free Access.
JoVE Science Education Coronavirus / COVID-19 Procedures
COVID-19 / Coronavirus Outbreak: Protecting The Airway – Endotracheal Intubation

COVID-19 / 코로나바이러스 발병: 기도 보호 - 내트라큐어 삽관

English

Share

Overview

전염병 시대에 의료진은 감염과 싸우는 데 중요한 자원이되고 있습니다. 최고의 의료 서비스를 달성하기 위해 관련 기술과 절차는 감염위험을 줄이기 위해 의료진에게 가르쳐야 합니다. COVID 환자는 종종 예후 호흡 부족으로 인해 기계적 환기가 필요하므로 내트라큐어 관충은 이러한 환자를 관리하는 중요한 절차가됩니다. 이 절차는 에어로졸 형성과 안전하지 않은 기도로 인해 감염의 위험이 증가합니다. 환자의 안전은 무시해서는 안되며 저혈증과 포부와 같은 합병증은 피해야합니다. 동시에 전염병 위기에 있는 인적 자원을 보존해야 하기 때문에 감염으로부터의 개인 보호가 가장 중요합니다. 이 비디오는 개인 감염 보호를 고려하는 동안 내결핵 삽관의 절차를 보여줍니다.

Procedure

이 프로토콜의 주요 목적은 에어로졸 형성및 신속한 시퀀스 유도의 감소입니다. 이 프로토콜에 대한 몇 가지 중요한 권장 사항이 있습니다 : 초기 삽관에 대한 낮은 임계 값을 잡고, 첫 번째 줄에서 비디오 후두를 사용하고, 에어로졸 형성을 줄이기 위해 고류 산소 요법을 피하고, 방에서 가능한 한 적은 인력을 가지고 있으며, 준비 및 절차를 위해 체크리스트를 사용합니다. 환자 실 밖에서 필요한 재료를 준비합니다. 팀에 개요를 제공합니다. Donn 개인 보호 장비 (가운, 모자, 고글, 장갑)뿐만 아니라 개방형 기도로 작업하기위한 추가 장비 : FFP3 / N-95 마스크, 바이저 및 두 번째 장갑. 이중 필터를 인공호흡기에 연결하고 인공호흡기 튜브의 연결 점을 확인합니다. 보류 중인 절차에 대해 환자에게 알리고 동의를 얻습니다. 혈역학 모니터링(심전도, SpO2, NBP)을 얻습니다. 상체를 상승시켜 환자의 위치와 삽관 요구 사항을 최적화합니다. 흡입 장치를 테스트합니다. 정맥 액세스 테스트(최소 2). 전체 팀 중지: 10분 원칙에 대해 10초(문제, 의견, 사실, 계획 토론) 및 프로세스 체크리스트를 따르십시오. 산소 공급을 중지 (장소에 O2 비강 캐뉼라를 두고), 환자의 보호 마스크를 제거합니다. 호흡 마스크를 놓고 양손으로 조입니다. 3 리터 / 분에서 O2 비강 캐뉼라를 통해 산소 공급을 시작합니다. 3-5 분 동안 인공 호흡기 (압력 지지없이 CPAP, PEEP 5 mbar)로 FiO2 1.0으로 사전 산소화를 시작합니다. 혈역학을 확인하고 저혈압에 대한 혈관 제기자를 준비하십시오. 마취제와 근육 이완제를 신속하게 투여하고 적어도 45초 이상 기다립니다. 이것은 좋은 삽관 조건을 달성하고 환자가 삽관 도중 기침하지 않도록 하기 위하여 행해지습니다. 비강 캐뉼라를 통해 산소 공급을 중지한 다음 인공호흡기를 중지합니다. 호흡 마스크를 제거하고 환자 옆에 안전하게 놓습니다. 보호되지 않은 기도에 너무 가까워지는 것을 피하기 위해 비디오 후두를 사용하여 내트라큐레이션 삽관을 수행합니다. 튜브가 제자리에 있는 즉시 커프스를 차단합니다. 통합 폐쇄 흡입 장치와 인공호흡기를 연결합니다. 인공호흡기 튜브의 연결 부위를 확인합니다. 인공호흡기를 시작합니다. capnography 및 auscultation으로 올바른 튜브 배치를 확인하십시오. O2 비강 캐뉼라 제거 내막 튜브를 수정합니다. 외부 장갑을 제거합니다. 비위 튜브를 삽입합니다. 예기치 않게 어려운 기도의 경우, 에어로졸 형성의 위험이 낮기 때문에 마스크 환기보다 수프라게틱 기도 장치가 선호됩니다. 어려운 기도에 필요한 모든 재료는 오염된 지역 외부에 배치되어야 하며 추가 도우미에 대한 빠른 액세스가 보장되어야 합니다.

Disclosures

No conflicts of interest declared.

Transcript

Dearest colleagues. The aims of early intubation in COVID-19 patients with respiratory failure are both to prevent aerosolization of respiratory tract fluids and avoid intubation under emergency conditions.

A low threshold for early intubation of COVID-19 patients should be held and a modified rapid sequence induction with videolaryngoscopic intubation utilized. High-flow or non-invasive ventilation therapy should be avoided, and if not possible, used for the shortest period of time.

Fiber optic intubation should also be avoided due to risk of aerosolization. All necessary equipment for intubation is prepared outside of the patient’s room.

The team should be kept to the minimal number of personnel required to carry out the procedure. Typically, this would consist of one intubating doctor, a doctor with oversight who also manages the cardiovascular system, a nurse or operating department assistant to operate the ventilator, and a second nurse or operating department practitioner to apply the anesthetic agents and supply intubation equipment.

Additionally, there should be a runner assigned to wait outside of the room. In case additional equipment or materials are needed, an intubation checklist, which is tailor-made by every hospital according to their resources will now be carried out by the second doctor and will be clearly communicated to the team.

The airway trolley is placed outside of the room so that all potential and necessary airway equipment is quickly available. This includes supraglottic airway devices, such as laryngeal mask airways and esophageal tracheal double-lumen airways. The on-call EMT tracheostomy team should also be contactable and the telephone number known.

The connecting ports of the prepared ventilator are tested. An HME filter is connected between the Y-piece and the respiratory mask. The patient is informed of the anesthesia and intubation procedure in order to attain informed consent.

Complete vital sign monitoring is to be carried out and the ECG tone switched on. The working environment must be optimized. Ensure enough space is around the bed. The pillow is removed, and the patient positioned in a head-up position. The suction system must be fully functional with the suction catheter attached and in reaching distance of the intubating doctor. The patient should have a minimal of two intravenous cannulas, which are tested prior to intubation.

Before beginning the procedure, the team must follow a 10 second for 10 minute principle where facts, procedural planning, potential complications, and team roles are clarified and outstanding questions can be answered. The second doctor also reads and ensures that the recommendations in the airway protection checklist in COVID-19 patients is sufficiently completed. The procedure may begin once everything is clarified.

The oxygen supply to the nasal cannula is turned off. The patient’s protective mask then removed. The respiratory mask is placed and held directly on the patient’s mouth and nose with a C-grip technique. As soon as the mask is airtight, oxygen is provided through the nasal cannula at a flow rate of 3 liters per minute. The ventilator is set to a CPAP mode without pressure support and with a PEEP of 5 and FI02 of 1. The patient should be pre-oxygenated for a total of three to five minutes.

Meanwhile, the patient’s cardiovascular state is monitored, and if required, catecholamine therapy initiated. Now, the five minutes are over. In the context of a rapid sequence induction, all anesthetic agents are rapidly applied. The purpose is to achieve a rapid and deep state of anesthesia without eliciting a cough reflex or hiccup. There will be a 45-second pause after the application of muscle relaxants.

The oxygen supply over the nasal cannula is stopped. However, the nasal cannula is left in place. The ventilator is also paused. The respiratory mask is either hung to the side or placed in a kidney dish next to the patient’s head and held by the assistant positioned near the ventilator. Intubation will now be attempted through videolaryngoscopy and with an endotracheal tube with a pre-positioned bougie within. It is important to maintain as much distance as possible between the intubating doctor and the patient.

After the removal of the bougie, the endotracheal tube cuff must be blocked quickly to prevent aerosolization. The assistant detaches the respiratory mask from the breathing circuit, and places this, in turn, in a kidney dish. A closed suction system is attached to the breathing circuit and once any leaks are eliminated, ventilation can be continued.

The tube position is confirmed through capnography and auscultation. Contamination can be minimized by having a dedicated stethoscope for each patient, which is left by the patient’s bed. Now, the nasal cannula are cut and removed. The endotracheal tube is then fixed. The first pair of gloves are removed and disposed of.

Now, a nasogastric tube should be inserted and its position checked and then fixed. Per the procedures, difficult airway algorithms are well established and are also relevant in COVID-19 patients. The airway or emergency trolley is pre-prepared with all potentially necessary equipment and is placed outside of the patient room.

An allocated runner is made available to pass any equipment on to the intubated team. Supraglottic airways, such as a laryngeal tube should be utilized early on in the algorithm. This is because the potential for leakage or aerosolization of respiratory tract droplets is lower than when compared to bag mask ventilation through a normal respiratory mask. If a second intubation attempt is required, then cricothyroid pressure can be applied. If a further attempt is required, then the second doctor from the team may carry this out.

Early consideration of the need for additional personnel or technical assistance is important as donning of personal protection equipment requires significant time. If a surgical airway is necessary, such as an emergency tracheotomy, then EMT colleagues must be informed early on. Extubation should be carried out by a team of two individuals with full personal protection equipment.

The first person stands next to the ventilator. The second loosens the endotracheal tube fixation tape and operates the closed suction system. The patient is ventilated with an FI02 of 1.0 prior to extubation and with a PEEP of 5. The ventilator is placed on standby immediately prior to extubation. The patient must then be continuously suctioned whilst the endotracheal tube is carefully removed.

The breathing system may not at any point be disconnected. A tight-fitting respiratory mask is placed on the patient covering the mouth and nose, and all vital signs with particular attention to the respiratory function must be monitored.

Thank you.

Tags

Cite This
JoVE Science Education Database. JoVE Science Education. COVID-19 / Coronavirus Outbreak: Protecting The Airway – Endotracheal Intubation. JoVE, Cambridge, MA, (2020).